ZX261D/361D/371D

Back conveyor height adjustment system

Automatic operation interface

Chain & bearing combined conveyor

Machine Introduction

This machine is designed to make bevel on small glass and big glass.  The back conveyor track can be moved up and down according to glass size.  For small glass size, the back conveyor track can be moved upward.  For big glass size, the back conveyor track can be moved downward.

This machine adopt PLC control and operator interface.  The Screen can show glass thickness, bevel angle, bevel width and back track height.

Basement and frame are made of cast iron to ensure stability and solidity.

Back Conveyors use chains transmitting system.  The pads are connected by single big roller chain. Each pad has a guide bearing, which guarantee high precision when conveyor is running on the tracks.

The pads of front conveyor have changeable rubber pads which are specially designed to grip small glass 30mm, which can be replaced independently after wear-off.  This structure guarantee glass is stably moved.  The working precision is high.

Back conveyor has cleaning brush, which ,maintain a clean surface and guarantee working result.

Motor use high precision low vibration ABB motor, specially for beveling machine.

Loading/offloading conveyor adopt timing belt.

Front rail movement is motorized, it can move in parallel to adapt to different glass thickness.  There is a mechanical thickness readout to show conveyor opening.

Glass support frame use aluminum bar with blue plastic roller.

The machine is equipped a manual lubrication pump, which lubricate the sliding part of motor plate and front conveyor moving system.  Front and back conveyor should be greased by solid grease.

Working speed adjustment is through speed regulator, manually.

Amperometer meter check the wheel absorption.

Water system

Water is circulated in the machine and stainless water tank.  Wheel tank outlets connect with one stainless drain pipe which is very easy for installation.  The square water tube for water inlet is connected with each wheel nozzle.

Back pads washing unit

Technical parameters